Selecting a Data Set

Note: Create the Bench Review by lab number or by panel. Set up a panel before selecting a data set for the panel. See "Create a Panel and Add Tests" for more information.

1. Log in as a user with the Bench review permission.
2. Click the Review tab.
3. Click Bench Review.
4. Select the Lab or Panel option.
5. Select the option for the data to review:
   • All data
     By default, the All data option is selected. The Bench Review shows all data, regardless if the data violated any active SPC rules.
   • Suspect data

     The Bench Review show only rejected data points and data points violating an active (reject or warn) SPC rule.

     Note: Click the appropriate option to switch between All data and Suspect data.

6. Select a lab number from the Lab number list or select All.
7. Select a lot number from the Lot number list or select All.
8. Select an instrument from the Instrument list or select All.
   • UnityWeb™ shows the data in the selected data set and includes any item selected in the Show Columns dialog box (value, evaluation mean, evaluation standard deviation (SD), and/or any attached actions and comments). See "Manage Columns" for more information.
   • Data violating a SPC rule with a status of reject is highlighted in red.
   • Data violating a SPC rule with a status of warn is highlighted in yellow.
   • Data not violating a SPC rule but within the same run as a data point violating a SPC rule with a status of reject or warn is highlighted in white.
   • Non-suspect data or accepted runs are is highlighted in white.
9. Continue with the next section, "Review Data."